[KwartzLab] 3D Printer: Next Steps

[Kevin Martin]

Now, are we sure our thermocouple board uses the DS2760 "High-Precision Li+ Battery Monitor" chip? This is what this particular web page is for.

I was under the impression we had a MAX6675 "Cold-Junction-Compensated K-Thermocouple-to-Digital Converter (0°C to +1024°C)".

Get out the magnifier and stare at the chip on the thermocouple controller.

-Kevin Martin
 the Papertrail Handmade Paper & Book Arts
 New Dundee, Ontario, Canada
 www.papertrail.ca



-----Original Message-----
From: discuss-bounces at kwartzlab.ca [mailto:discuss-bounces at kwartzlab.ca] On Behalf Of doug moen
Sent: Monday, August 29, 2011 10:19 AM
To: KwartzLab Public Discussion List
Subject: Re: [KwartzLab] 3D Printer: Next Steps

Just for the record, Tech Zone recommends the following software toolchain.

Firmware: http://www.reprap.org/wiki/TechZone_Tip_Assembly#Firmware_Files

STL->GCODE: 3dtoolchain.com (web application created by TechZone)

Printing the GCODE: repsnapper (for now)

_______________________________________________
Discuss mailing list
Discuss at kwartzlab.ca
http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca