[KwartzLab] 3D Printer: Next Steps

[Kevin Martin]

A close-up photo reveals that the chip is a DS2762A so this software recommendation might actually be correct.

-Kevin Martin
 Thinkage Ltd.

________________________________________
From: discuss-bounces at kwartzlab.ca [discuss-bounces at kwartzlab.ca] on behalf of Kevin Martin [kpmartin at thinkage.ca]

Now, are we sure our thermocouple board uses the DS2760 "High-Precision Li+ Battery Monitor" chip? This is what this particular web page is for.

I was under the impression we had a MAX6675 "Cold-Junction-Compensated K-Thermocouple-to-Digital Converter (0°C to +1024°C)".