[KwartzLab] Making a spoked, wooden wheel
robadlers at gmail.com
Tue Nov 15 11:24:42 EST 2011
See, and here I was thinking you should visit one of the local wagon repair shops. I remember one north of waterloo on a back road to Elmira.
via my Blackberry
From: Kevin Martin <kpmartin at thinkage.ca>
Sender: discuss-bounces at kwartzlab.ca
Date: Tue, 15 Nov 2011 16:17:30
To: KwartzLab Public Discussion List<discuss at kwartzlab.ca>
Reply-To: KwartzLab Public Discussion List <discuss at kwartzlab.ca>
Subject: Re: [KwartzLab] Making a spoked, wooden wheel
If you really want utilitarian, you could use a bicycle wheel with the tire removed...
This is not beyond my capabilities, but I don't have a lathe that big, so I would have to improvise using my mill and bandsaw.
The rim would be pieced together, and a router table would be useful for making finger joints between the segments.
Given that Kwartzlab has a bandsaw and router table you should (perhaps with help) be able to make this in the lab. The mill is not essential; I would only be using it to cut the belt groove, and that could be done with a rasp as well.
the Papertrail Handmade Paper & Book Arts
New Dundee, Ontario
From: discuss-bounces at kwartzlab.ca [mailto:discuss-bounces at kwartzlab.ca] On Behalf Of Punkin3.14
I'm a complete novice at woodworking, but I'm working from a very utilitarian model (i.e., non-decorative), and most of the pieces are straightforward to cut.
The bit that I am puzzling over is the fly wheel itself. Its 19" inches across, and needs a 1/4" rounded groove along the outer edge, which the drive band fits into. 
Have we any knowledgeable woodworkers who would be available sometime in the next couple months, to help me make such a wheel (assuming this is not an unreasonable project for a novice -- I honestly don't know how advanced this is)?
Discuss mailing list
Discuss at kwartzlab.ca
More information about the Discuss