[KwartzLab] improving our 3D print quality

[doug moen]

Yes, I did have them mixed up.  We have PLA, not ABS.  Geordie
straightened me out by showing me printed samples of both.

On 29 November 2011 10:25, Kevin Martin <kpmartin at thinkage.ca> wrote:
> Doug,
> Do you have PLA and ABS mixed up in part of this?
> "The usual recommended temperature for PLA is 190 C, but we have been
> printing at higher temperatures than this, which makes drooling worse.
> So we should try lower termperatures."
> As far as I know we have never extruded PLA.
>
> -Kevin Martin
>  the Papertrail Handmade Paper & Book Arts
>  New Dundee, Ontario
>  www.papertrail.ca
>
>
> _______________________________________________
> Discuss mailing list
> Discuss at kwartzlab.ca
> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca
>