[KwartzLab] Design software for the Laser Cutter

[Bill @ Waterloo Engraving]

What brand of laser is it?


James Bastow wrote:
> I'm not sure exactly what the workflow for the laser will be. As long 
> as your CAD software can export DXF, it should be fine.
>
> James
>
> On Sun, Oct 16, 2011 at 1:23 PM, Karl Williams <karlw at thinkbotics.com 
> <mailto:karlw at thinkbotics.com>> wrote:
>
>     Does anyone know what file format the laser cutter will be using?
>     Can I use my favorite CAD software and then export a .dxf?
>     I think James mentioned using adobe Illustrator and something
>     about lines drawn in red being the ones that would get cut?
>     It might be a little premature but now that it has been ordered I
>     want to start designing for it.
>
>     Take care, Karl
>
>     ______________________________ _________________
>     Discuss mailing list
>     Discuss at kwartzlab.ca <mailto:Discuss at kwartzlab.ca>
>     http://kwartzlab.ca/mailman/ listinfo/discuss_kwartzlab.ca
>     <http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca>
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Discuss mailing list
> Discuss at kwartzlab.ca
> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca
>   

-- 
Waterloo Engraving
100 Victoria St N, Unit F1
Kitchener, ON
N2H 6R5

		519-744-5666
      Fax 	519-957-1901
Toll Free 	877-393-6472

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://kwartzlab.ca/pipermail/discuss_kwartzlab.ca/attachments/20111016/dfe249c2/attachment.html>