[KwartzLab] 3D Printer: Next Steps
doug at moens.org
Sat Sep 10 19:21:22 EDT 2011
Okay, that's interesting news. I downloaded the techzone firmware and
diffed it against our firmware. It is definitely different, and the
#ifdef USE_DS2760 code is one of the major differences. I guess that
means I should load the TechZone firmware and see what happens.
On 30 August 2011 19:22, Kevin Martin <kpmartin at thinkage.ca> wrote:
> A close-up photo reveals that the chip is a DS2762A so this software recommendation might actually be correct.
> -Kevin Martin
> Thinkage Ltd.
> From: discuss-bounces at kwartzlab.ca [discuss-bounces at kwartzlab.ca] on behalf of Kevin Martin [kpmartin at thinkage.ca]
> Now, are we sure our thermocouple board uses the DS2760 "High-Precision Li+ Battery Monitor" chip? This is what this particular web page is for.
> I was under the impression we had a MAX6675 "Cold-Junction-Compensated K-Thermocouple-to-Digital Converter (0°C to +1024°C)".
> Discuss mailing list
> Discuss at kwartzlab.ca
More information about the Discuss