[KwartzLab] 0.1mm resolution 3D printing on the PrintrBot

[doug moen]

Here are some photos and discussion of high resolution (100 micron)
printrbot prints by regular users who have purchased the kit.
http://www.printrbottalk.com/forum/viewtopic.php?f=28&t=388

The print quality is much higher than we have managed to get out of
the reprap, with far less effort and tuning. These kits are very
cheap. $550 for a 6"x6"x6" print volume, or $700 for an 8"x8"x8" print
volume. And they are much easier to assemble: a few hours for one
person. It's a much simpler design, and the printhead and electronics
are preassembled.

I'd like to get one of these into the lab.