[KwartzLab] 0.1mm resolution 3D printing on the PrintrBot

[Ben Brown]

I'm willing to throw in $100 for a new 3d printer. Provided that this
one isn't also a lemon :)

Ben

On 4/30/2012 10:07 AM, Karl Williams wrote:
> I can do 0.1 mm on my reprap at home but those prints take a long time. I
> typically print the layers at .23 but skeinforge has a 'skin' function
> that will print the outer skin at half of your layer thickness (0.115 for
> my setting) so you still get the smooth surface and a quicker print time.
> I'll put some money into getting a printrbot for the lab if others want to
> do that too.
>
>> Here are some photos and discussion of high resolution (100 micron)
>> printrbot prints by regular users who have purchased the kit.
>> http://www.printrbottalk.com/forum/viewtopic.php?f=28&t=388
>>
>> The print quality is much higher than we have managed to get out of
>> the reprap, with far less effort and tuning. These kits are very
>> cheap. $550 for a 6"x6"x6" print volume, or $700 for an 8"x8"x8" print
>> volume. And they are much easier to assemble: a few hours for one
>> person. It's a much simpler design, and the printhead and electronics
>> are preassembled.
>>
>> I'd like to get one of these into the lab.
>>
>> _______________________________________________
>> Discuss mailing list
>> Discuss at kwartzlab.ca
>> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca
>>
>
>
> _______________________________________________
> Discuss mailing list
> Discuss at kwartzlab.ca
> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca