[KwartzLab] Sept 11 8pm workshop: how to use Don's CNC router

[Chris Bruner]

Excellent!
On 8/29/2012 8:31 PM, doug moen wrote:
> On Tuesday September 11 at 8pm, Don will give a presentation on how to
> use his CNC router. This talk will mostly be about the software
> toolchain, but also about tooling. How to take a drawing, convert it
> to GCODE, load the GCODE into Mach 3, and then run the job on the
> router.
>
> _______________________________________________
> Discuss mailing list
> Discuss at kwartzlab.ca
> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca
>


-- 
Chris Bruner