[KwartzLab] Laser Party! Tues, Jan 10

[Bill Jermyn]

Make sure you stay away from PVC, the hydrochloric acid produced by 
lasering is not only bad for your lungs, it'll rust the inside of the laser.

Darcy Casselman wrote:
> I dunno, but maybe I can run into Lens Mill on the way to the lab
> tomorrow and pick up some shiny yellow cotton- or rayon-based ribbon.
> I don't know what synthetic materials would be okay.
>
> Darcy.
>
> On Mon, Jan 9, 2012 at 11:01 AM, Ed Maste <carpeddiem at gmail.com> wrote:
>   
>> What ribbon (material) are we planning to cut?
>>
>> On 1/9/12, Darcy Casselman <dscassel at gmail.com> wrote:
>>     
>>> That's tomorrow,
>>>
>>> Sorry for the short notice. It's been discussed in person, but not so
>>> much on the list.
>>>
>>> Our official laser cutter ribbon cutting will happen tomorrow night
>>> during TON.  We'll have talks and demos and it'll be awesome.
>>>
>>> (It is my hope that we can get the laser cutter to cut its own ribbon,
>>> but as I'm not a trained laser cutter operator, I can't make that
>>> promise...)
>>>
>>> Darcy.
>>>
>>> _______________________________________________
>>> Discuss mailing list
>>> Discuss at kwartzlab.ca
>>> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca
>>>
>>>       
>> --
>> Sent from my mobile device
>>
>> _______________________________________________
>> Discuss mailing list
>> Discuss at kwartzlab.ca
>> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca
>>     
>
> _______________________________________________
> Discuss mailing list
> Discuss at kwartzlab.ca
> http://kwartzlab.ca/mailman/listinfo/discuss_kwartzlab.ca
>
>   

-- 
Waterloo Engraving
100 Victoria St N, Unit F1
Kitchener, ON
N2H 6R5

		519-744-5666
      Fax 	519-957-1901
Toll Free 	877-393-6472

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://kwartzlab.ca/pipermail/discuss_kwartzlab.ca/attachments/20120109/56f00624/attachment.html>