[KwartzLab] Chinese laser cutting service
digitalfalcon at rogers.com
Thu Apr 4 19:47:08 EDT 2013
Thanks for the link! Unfortunately, they don't do engraving, which my design uses quite a bit (and which is why it's so expensive on Ponoko)
On Apr 4, 2013, at 7:38 PM, Seth Hardy <shardy at asymptotic.ca> wrote:
> seeedstudio offers this service: http://www.seeedstudio.com/depot/laser-cutting-service-p-1009.html
> not sure it's good for small runs, haven't looked at the pricing.
> On Thu, Apr 4, 2013 at 6:41 PM, Jeff Schmidt <digitalfalcon at rogers.com> wrote:
>> Does anyone know if there is a Chinese laser cutting service that operates small runs, sort of like Gold Phoenix PCB? Yes, I know KwartzLab has a laser cutter, or I could go with Ponoko. But I have a lot to do, and cost is an issue too. Suggestions?
>> - Jeff
>> Discuss mailing list
>> Discuss at kwartzlab.ca
> seth hardy
> shardy at asymptotic.ca
> Discuss mailing list
> Discuss at kwartzlab.ca
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Discuss